Garland Rain Diverter Kit
Product Code: 244253
£8.99
- Kit includes: 1 x Rain Diverter, 1 x 20mm Connector, 1 x Washer, 1 x Nut, 1 x 500mm Hose
- Fits standard 68mm round or 65mm square plastic down pipes (not suitable for cast iron downpipes)
- BEWARE Do not use an electric drill if the butt contains any water
- Take the lid off the water butt. If your water butt is not predrilled then you will need to drill a 25mm hole to fit the rain diverter. Push connector through the washer from inside the butt, then fit and tighten the nut on the outside to form a seal.
- Position water butt with tap facing forward and adjust to down pipe. If using a stand place the butt on it. Mark the down pipe 10mm below the top of the butt. Mark again 30mm below this point, using a hacksaw. Cut out this section
- Fit rain diverter with square end up into the cut section of the down pipe. Release any clips supporting the down pipe in order to insert the rain diverter body and refit once diverter is in place. Then Connect hose between rain diverter body and the water butt connector.
Description
Description
Increase your green credentials and reduce your water bill simply by using this Garland Rain Diverter Kit in conjunction with a water butt. Used to link a water butt and your rain downpipe, it collects the rain that falls on your house roof, shed or greenhouse and diverts it into the water butt.
